Page 16 Operation Manual
A.3 Starting the Bookeye® 3 scanner
If the device has been used before and was constantly connected to power, the display
will show the message:
and the green START field above the Start button is
illuminated.
Picture 3: Display before power up
If the device was previously disconnected from the main power supply, the standby
message might not be visible. As long as the green START field above the Start button
is illuminated, the scanner can still be powered up by pressing the Start button.
Press the Start button. The background light immediately
lights up indicating that the device is starting.
The START field becomes dark and the STOP field will light up.
The next message in the display is:
The message is indicated for some seconds. Meanwhile the
device performs the basic hardware and software checks.
followed by:
This is the device name followed by
the firmware version
At this point during the power up cycle, the display will show:
for one second.
If the Start button is pressed during this interval, the display shows:
If the Start button is pressed again in the next three seconds
the IP address, gateway and subnet mask are all reset to
their factory defaults.
To Next Page
Loading...
Need help?
General
