Chapter 5 Function Code Table
- 42 -
Chapter 5 Function Code Table
5.1 Description of Function Codes
The NICE900 series door machine controller has a total of 13 groups of function codes,
namely, F0 to F9, FA, FF and FP. FX–YZ in this manual indicates the function code whose
function code group is "X" and whose function code is "YZ". For example, F3-02 indicates
function code "2" in group F3.
To facilitate the setting of the function codes, the operation panel adopts three-level menu.
The function code group is Level-I menu, function code is Level-II menu, and the setting value
corresponds to Level-III menu.
The meaning of each column in the function code table is as follows:
Function Code Indicates the function code number.
Parameter Name Indicates the parameter name of the function code.
Setting Range Indicates the setting range of the parameter.
Default Indicates the default setting of the parameter at factory.
Unit Indicates the measurement unit of the parameter.
Property
Indicates whether the parameter can be modied (including the modication
conditions)
The symbols in the function code table are described as follows:
"
☆
": The parameter can be modied when the NICE900 is in either stop or running state.
"
★
": The parameter cannot be modied when the NICE900 is in the running state.
"●": The parameter is the actually measured value and cannot be modied.
"*": The parameter is factory parameter and can be set only by the manufacturer.
The system automatically restricts the modication property of all parameters to prevent mal-
function.
"Default Value" indicates the value after parameter update when you restore factory settings,
but the actually detected parameter values or recorded values are not updated.
To protect the parameters more effectively, the NICE900 provides the password protection.
5.2 Function Code Table
After pressing
key and then or key, the Level-I menu is displayed,
corresponding to the following function code groups:
To Next Page
Need help?
General
