76
LBK System Series| Instruction manual v1.2 SET 2021 |SAF-UM-LBKBus-en-v1.2|© 2020-2021 Inxpect SpA
7. Maintenance and troubleshooting
3. Click DOWNLOAD LOG.
7.2.3 Log file sections
The first line of the file reports the NID (Network ID) of the device and the date of the download.
The rest of the file log is divided in two sections:
Section Description Content Size Reset
1 Event log Information
events
Error events
3500 At every firmware update or on demand using the Inxpect
Safety application
2 Diagnostic
event log
Error events 1000 Not possible
7.2.4 Log line structure
Each line in the log file reports the following information, separated by tab character:
l Timestamp (seconds counter from the latest boot)
l Timestamp (absolute/relative value)
l Event type:
o
[ERROR]= diagnostic event
o
[INFO]= information event
l Source
o
CONTROL UNIT = if the event is generated by the control unit
o
SENSOR ID =if the event is generated by a sensor. In this case is provided also the node ID of the
sensor.
l Event description
Timestamp (seconds counter from the latest boot)
An indication of the instant when the event occurred is provided as relative time from the latest boot, in seconds.
Example: 92
Meaning: the event occurred 92 seconds after the latest boot
Timestamp (absolute/relative value)
An indication of the instant when the event occurred is provided.
l After a new system configuration, it is provided as absolute time.
Format: YYYY/MM/DD hh:mm:ss
Example: 2020/06/05 23:53:44
l After a reboot of the device, it is provided as relative time from the latest boot.
Format: Rel. x d hh:mm:ss
Example: Rel. 0 d 00:01:32
Note: when a new system configuration is performed, even the older timestamps are updated in absolute time
format.
Note: during system configuration, the control unit is receiving the local time of the machine where the software is
running.
To Next Page
Loading...
Need help?
General
