SCPI Introduction
Copyright © Itech Electronic Co., Ltd. 23
2.8 Subsystem Commands
Subsystem commands are specific to functions. They can be a single
command or a group of commands. The groups are comprised of commands
that extend one or more levels below the root. The description of common
commands follows the description of the subsystem commands.
The subsystem command groups are arranged according to function:
Calibration, Channel, Input, List, Measurement, Port, Status, System, Transient,
and Trigger. Commands under each function are grouped alphabetically under
the subsystem. Commands followed by a question mark (?) take only the query
form.
When commands take both the command and query form, this is noted in the
syntax descriptions.
To Next Page
Loading...
Need help?
General
