ITech IT8800 Series User Manual

References of Load Communication Interfaces
Copyright © ITECH Electronic Co., Ltd. 82
(each end). All functions of the load can be programmed via USB.
The functions of load USB488 interface are as follows:
 The interface is 488.2 USB488 Interface.
 The interface receives requests of REN_CONTROL, GO_TO_LOCAL and
LOCAL_LOCKOUT.
 The interface receives the command MsgID=TRIGGER USBTMC and
conveys the TRIGGER command to the functional layer.
The functions of load USB488 device are as follows:
 Capable to read all common SCPI commands.
 SR1 enabled.
 RL1 enabled.
 DT1 enabled.
5.3 GPIB interface
Firstly, connect load GPIB interface and computer GPIB card through IEEE488
bus and ensure sufficient contact. Tighten them with screws. Set address. Load
address range: 0-31. Press [Shift] + 5 to enter system menu functions. Press
Left/Right key to find Communication. Select GPIB and set address. Input
address and press [Enter] for confirmation. The load works by setting GPIB
address on front board. GPIB address is saved in NVM.

ITech IT8800 Series Specifications

General

Brand	ITech
Model	IT8800 Series
Category	Test Equipment
Language	English