1 CONTENTS
en-1
1Contents
FOREWORD
This manual contains adjustment, maintenance, and
troubleshooting instructions for your new Jacobsen
machine. This manual should be stored with the
equipment for reference during operation.
Before you operate your machine, you and each operator
you employ should read the manual carefully in its
entirety. By following the safety, operating and
maintenance instructions, you will prolong the life of your
equipment and maintain its maximum efficiency.
If additional information is needed, contact your
Jacobsen Dealer.
SERVICE SUPPORT MATERIAL
Part No. Description
673833
Safety, Operation & Maintenance Manual
673836
Parts Manual
4299117
Kubota V2403-E4B Engine Parts Manual
689300
Kubota V2403-CR-E5B Engine Parts Manual
Part No. Description
© 2020 Textron Specialized Vehicles
This manual may not re reproduced in whole or in part without the express permission of TSV Technical Communications Department.
09-2020
CALIFORNIA PROPOSITION 65
WARNING
The engine exhaust from this product contains
chemicals known to the State of California to cause
cancer, birth defects and other reproductive harm.
!
Blade Recommendations
AR530 - 23” BLADE RECOMMENDATION
DISCHARGE MODE MULCH MODE COMMENTS
Vortex Combo Best cut quality; good distribution
Good hiding of clippings for cool and warm
season grasses; best quality cut
Best all around blade in cool and warm
season grasses
692774 Good all around blade Sometimes best blade for Bermuda
Extreme Mulch
In certain conditions best distribution, but
some degradation in cut quality
Best blade for hiding, but some degrada-
tion in cut quality
Performance is very dependent on spe-
cific local conditions
692775 Often the best blade for Bermuda Often the best blade for Bermuda
High Lift Use for very heavy conditions Not recommended Not Available for European Market
692771
Helps with distribution in cool season
grass, especially in the Spring
Not recommended
Note:
* These recommendations are intended as an initial guide for blade selection.
Grass type, regional climates, height of cut, and customer preferences will affect the actual blade choice.
** Due to sound level regulations, some blades may not be available in all regions. Please check with your local dealer for
availability.
To Next Page
Loading...
Need help?
General
