OPERATION 5
en-49
5Operation
5.1 DAILY INSPECTION ________________________________________________________
Do a visual inspection of the mower. Look for indications of wear or loose hardware. Look for any components that are
not included on the mower or damaged components. Check for fuel and oil leaks to make sure the connections are
tight. Make sure that all hoses and tubes are in good condition.
Check the fuel supply, radiator coolant level, crankcase oil level, hydraulic oil level and air cleaner indicator. When the
engine is cold, all fluids must be at the full level mark.
Check the radiator fins for dirt or grass. Clean with compressed air as required before you operate the mower.
Make sure all cutting implements are adjusted to the same cutting height. See Section 6.9
Check all tires for the correct pressure. See Section 7.1
Test the interlock system. See Section 5.2
CAUTION
The inspection must be done each day when the engine is turned off and all fluids are cold. Lower the cutting
implements to the ground, engage the parking brake, stop the engine and remove the ignition key.
!
To Next Page
Loading...
Need help?
General
