Page 41
12.1 Programming the Heating Mode
Your Jacuzzi spa is equipped with 3 modes of heating, Figure 12.1a. An
automatic mode called “Auto,” where the spa’s temperature is maintained
at all times. An energy saving heating cycle called “Econo.” A mode that
will only activate the heater during the daytime called “Day” mode.
Note: The heater will activate when the temperature drops 2° from the
set temperature.
Indicates that the feature is active. Indicates that the feature is not
active.
A. Auto heating:
1. When programmed to “Auto,” the spa
will maintain the water temperature to
the set temperature. Heating will occur
when necessary.
2. To select this mode, tap next to the
“Auto” icon.
B. Econo heating:
1. This is an energy saving heating program that allows the spa to heat
during non-peak hours. When programmed to “Econo,” the spa will
only be allowed to heat the water between 5:00 PM to 7:00 AM every
day of the week. The hours cannot be adjusted.
2. To select this mode, tap next to the “Econo” icon.
C. Day heating:
1. When programmed to “Day,” the spa will only be allowed to heat the
water between 7:00 AM to 5:00 PM every day of the week. The hours
cannot be adjusted.
2. To select this mode, tap next to the “Day” icon.
12.2 Programming the Primary Filter
To access the “Primary Filter” feature, you need to use the Slider Bar to
scroll down to the “Heat & Filter” menu, Figure 12.2a and 12.2b. Once
you scroll down, tap
>
to enter the “Primary Filter” programming, Figure
12.2c.
Econo
Day
Auto
HEAT & FILTER
Figure 12.1a
Figure 12.2a
Figure 12.2b
Econo
Day
Auto
HEAT & FILTER
Primary Filter
Secondary Filter
HEAT & FILTER
>
>
To Next Page
Loading...
Need help?
General
