Page 46
D. Programming the Water Change Timer
A programmable “Water Refresh” reminder can be set to remind you
when to drain and rell the spa.
1. While in the “Water Care” Menu, Figure
12.6e, tap
>
or
>
until you reach the
“Water Change” option, Figure 12.6f.
2. Slide your nger up and down to roll
the days scroll wheel to adjust the
number of days from OFF to 180. The
adjustments are made in increments
of 30 days. The days are stored in memory if the
power is interrupted.
Note: It is not recommended that this feature be turned OFF. In order to
continually maintain the water healthy and clean, in addition to chemical
maintenance, it should be program as instructed.
3. Tap
to conrm and save your changes.
4. When the timer expires, a message will appear on the control panel
display, page 67. The water must be drained and replaced with
fresh water. Follow the instructions above to reset the timer. If you
tap “snooze” the message will clear but the error icon will display
and the reminder screen will reappear in 10 days. Refer to Section
13.1, page 51, for lter location.
12.7 Locking the Spa
From the “Settings” menu, tap
>
next to “Lock” to enter the programming
options, Figures 12.7a and 12.7b. You can prevent users from changing
certain features of the spa. When a lock feature is active, the lock icon
will appear of the status bar. When you enter the “Lock” menu, if one of
the three settings is active, it will be highlighted orange.
Water Care
set to
180
0 days
Water refresh
>
Set
>
Figure 12.6f
Time & Date
Language
Lock
SETTINGS
>
>
>
LOCK
0000
set lock level
lockunlock
temp spa service
Figure 12.7a
Figure 12.7b
To Next Page
Loading...
Need help?
General
