Page 43
12.3 Programming the Secondary Filter
To enter the Secondary Filter program,
tap
>
from the heat and lter menu, Figure
12.2b. The display will change to Figure
12.3a. During a secondary ltration, the Jets
Pump 1 is activated. There are 3 cycles you
can select from, Figure 12.3a. The factory
default cycle is “Away Mode.” If you elect to
keep this setting, then you can skip this section.
Indicates that the feature is active. Indicates that the feature is
not active.
A. To change the Secondary Filter cycle:
1. Away Mode: Secondary Filtration is disabled. To activate this mode,
tap next to the “Away” icon.
Note: This is the factory default setting.
2. Infrequent Mode: Activates two cycles at 8:00 PM and 8:00AM
every other day. Each cycle will last 10 minutes for a total of 20
minutes every other day. To activate this mode, tap next to the
“Infrequent” icon. Time and duration cannot be altered.
3. Frequent Mode: Activates two cycles at 8:00 PM and 8:00AM every
day. Each cycle will last 10 minutes for a total of 20 minutes every
day. To activate this mode, tap next to the “Frequent” icon. Time
and duration cannot be altered.
12.4 Cleaup Cycle
The cleanup cycle occurs once per day at 12:00 pm (noon) for two
minutes. This is not user programmable. The Jets Pump 1 and the
Circulation Pump will turn on for one minute and then shut off. Then Jets
Pump 2 will turn on and run for 1 minute then shut off. Turning off the
corresponding jets pump that is running can deactivate the feature.
12.5 Blow-Out Cycle
This cycle will purge the air from the plumbing lines normally caused by
draining and lling the spa. The Jets Pump 1 and the Circulation Pump
will turn on for 1 minute and then shut off. Then Jets Pump 2 will turn
on and run for 1 minute then shut off. Turning off the corresponding jets
pump that is running can deactivate the feature. This cycle will only
occur:
• At start up.
• After exiting a service lock.
Secondary Filter
Away
Infrequent
Frequent
Figure 12.3a
To Next Page
Loading...
Need help?
General
