To Next Page

To Previous Page

 Consider locang your swim spa away from any reﬂecve surface or glass to prevent any

damage to the synthec skirt.

 When possible, do not shim the swim spa. To ensure proper support the swim spa must

sit ﬂat on the intended foundaon.

4.2 Indoor Locaon

For indoor installaons many factors need to be considered before installing a spa indoors.

WARNING: In addion to maintenance of ﬁlters and water chemistry, proper ven-

laon is recommended to reduce the risk of contracng waterborne illness (e.g. an

infecon, bacteria or virus) and/or respiratory ailments that could be present in the

air or water. Consult a licensed architect or building contractor to determine your speciﬁc

needs if installing your swim spa indoors.

 Proper Foundaon: Consult a Structural Engineer when considering a foundaon that

will adequately support the swim spa the enre me it is in place. Proper support is

crical especially if the spa is to rest on a second story or higher. For swim spas that are

to rest on roofs or other plaorms not speciﬁcally ed into the main structural support,

you should consult a professional Structural Engineer with experience in this type of ap-

plicaon.

 Proper Drainage: It is extremely important to have in place measures to suﬃciently

handle excessive water spillage. Be sure the ﬂooring in which the swim spa rests on has

adequate drainage and can handle the enre contents of the swim spa. Be sure to make

provisions for ceilings and other structures that may be below the swim spas installaon.

Areas around your swim spa can become wet or moist so all ﬂooring and subsequent fur-

niture, walls and adjacent structures should be able to withstand or resist water and

moisture.

 Proper Venlaon: Proper venlaon should be discussed with an Engineer or authori-

ty competent enough to understand the necessary provisions needed to vent moist or

heated air and air associated with chemical odors outdoors. When the swim spa is in

use considerable amounts of moisture will escape, potenally causing mold and mildew

over me, which can damage certain surfaces and/or surroundings.

 Suﬃcient Access: In the likely event that you should ever need to access or gain entry to

any poron of the swim spa for servicing, it is highly recommended that you plan your

indoor installaon to provide full access to the enre swim spa.

Jacuzzi SWIMSPA Power Actve J16 User Manual

Questions and Answers: