38
Purge Cycles
In order to maintain sanitary condions, as well as protect against freezing, secondary water
devices will purge water from their respecve plumbing by running briefly at the beginning of
each filter cycle. (Some systems will run a certain number of purge cycles per day, independ-
ent of the number of filter cycles per day. In this case, the purge cycles may not coincide with
the start of the filter cycle).
If the Filter Cycle 1 duraon is set for 24 hours, enabling Filter Cycle 2 will iniate a purge
when Filter Cycle 2 is programmed to begin.
10.8 Light Cycle Opon
If the Light Cycle does not appear on the Sengs Screen, the Light Timer feature is not ena-
bled. The Light Cycle Icon on the Sengs Screen takes you to a screen where you control the
Light Cycle. When available, the Light Timer is (‘Disabled”) by default. Press “Disabled” to
change it to “Enabled” (ON). The sengs can be edited the same way that the Filter Cycles
are edited.
Brightness Up Buon: Tap to raise the intensity of the lights to the maximum level of 5. The intensi-
ty levels are as follows: 5 = 100%, 4 = 80%, 3 = 60%, 2 = 40%, 1 = 20% and 0 = 0%.
Brightness Down Buon: Tap to lower the intensity of the lights to the minimum level of 0.
Intensity Indicator: Displays the current intensity level of the lights by the number of bars filled in.
this will only work with the solid color opon. If the blending mode is on, the light bulb is grayed out.
The range is from 0 to 5.
Speed Control Buon (Increase): Tap to increase the blending speed of the colors to the maximum
speed of 5. The speed sengs are as follows: 5 = every 5 secs, 4 = every 10 secs, 3 = every 15 secs, 2 =
every 30 secs and 1 = every 60 secs.
Speed Control Buon (Decrease): Tap to decrease the blending speed of the colors to the minimum
speed of 0.
Color Selector: Tap a color to select a single color.
Back Buon: Tap to go back to the previous menu.
Invert Buon: Tap to invert the display image.
To Next Page
Loading...
Need help?
General