EasyManuals Logo
Home>Jacuzzi>Hot Tub>SWIMSPA Power Actve J16

Jacuzzi SWIMSPA Power Actve J16 User Manual

Jacuzzi SWIMSPA Power Actve J16
57 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #44 background imageLoading...
Page #44 background image
44
9. To completely flush the old water from the plumbing lines: allow fresh water to ll into
the foot-well area while the old water connues to be pumped out. Always keep at least
10cm (4 in.) of water in the foot-well so that pump 1 remains primed.
10. When the water from the drain hose turns clear (indicang fresh fill water), flush is com-
plete.
11. Turn OFF the filtraon pump.
12. Close the drain-hose bib on the swim spa plumbing line and con-
nue filling swim spa with fresh water.
13. Place cover on swim spa (to avoid splash-out).
14. Open filtraon pump return gate valve.
15. Press any buon on the topside control panel (other than the pump 1 buon) to take
the system out of STANDBY/DRAIN ASSIST mode. Filtraon pump and the heater will ac-
vate to circulate and heat the water while filling connues. This also reduces the possi-
bility of an airlock occurring.
16. Connue adding fresh fill water unl level is approximately 19mm (3/4 in.) from the top
of the skimmer opening.
12.3 Cleaning the Swim Spa Interior
To preserve the sheen of your swim spa’s surface, it is crucial that you avoid using abrasive
cleaners or cleaners which have adverse chemical effect on the surface. If you are not certain
as to the suitability of a parcular cleanser, consult your authorized Jacuzzi dealer. We recom-
mend using Jacuzzis Spa All Purpose Cleaner to clean the swim spa’s interior surface. Use ex-
treme care to assure that no soap residue is le on the surface. This could cause severe
sudsing when the swim spa is refilled. Jacuzzi chemicals are for use in the U.S. only.
12.4 Pillow Care
Clean the headrests in your swim spa as needed by wiping them with a cloth with soapy wa-
ter. It is not necessary to remove the headrests for cleaning. To remove headrests for long
term storage or replacement, grasp both ends of each headrest and gently pull inward to-
wards the center of the swim spa. To reinstall, over mounng strip and press down unl head-
rest mounng bracket emits a “click” sound. Then adjust the headrest height by simply mov-
ing up or down as desired.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Jacuzzi SWIMSPA Power Actve J16 and is the answer not in the manual?

Jacuzzi SWIMSPA Power Actve J16 Specifications

General IconGeneral
BrandJacuzzi
ModelSWIMSPA Power Actve J16
CategoryHot Tub
LanguageEnglish

Related product manuals