C
D
B
A
❷
❶
D
B
C
A
– 13 –
Use the specied needle for the machine. Use the
proper needle in accordance with the thickness of
thread used and the kinds of the materials.
1) Turn the handwheel until the needle bar reaches
the highest point of its stroke.
2) Loosen screw
❷
, and hold needle
❶
with its
indented part
A
facing exactly to the right in direc-
tion
B
.
3) Insert the needle fully into the hole in the needle
bar in the direction of the arrow until the end of
hole is reached.
1) Turn the handwheel to lift the needle above the
throat plate.
2) Install the bobbin in the bobbin case so that the
thread wound direction is clockwise.
3) Pass the thread through thread slit
A
of the bob-
bin case, and pull the thread in direction
C
. By
so doing, the thread will pass under the tension
spring and come out from notch
B
.
4) Check that the bobbin rotates in the direction of
the arrow when thread is pulled.
5) Pinching latch
D
of the bobbin case with ngers,
t the bobbin case in the hook.
3. PREPARATION BEFORE SEWING
3-1. Attaching the needle
3-2. Removing/tting the bobbin case
WARNING :
Turn OFF the power before starting the work so as to prevent accidents caused by abrupt start of the
sewing machine.
WARNING :
Turn OFF the power before starting the work so as to prevent accidents caused by abrupt start of the
sewing machine.
4) Securely tighten screw
❷
.
5) Check that long groove
C
of the needle is facing exactly to the left in direction
D
.
To Next Page
Need help?
General
