5-2. Adjusting the needle thread presser device
[Feature]
The needle thread presser device is able to tuck the
needle thread on the wrong side of material as in the
case of the conventional wiper device.
• Operability around the needle entry point is im-
proved.
• Applicability of various kinds of attachments de-
signed for use around the needle entry point is
improved.
WARNING :
Turn OFF the power before starting the work so as to prevent accidents caused by abrupt start of the
sewing machine.
Display
section C
[How to set the needle thread presser device]
Keep thread presser operation enable /
disable switch
held pressed to
change over the ON/OFF of the thread
presser.
When the thread presser device is set to
ON, the thread presser icon is displayed
on display section
C
.
In the case the memory switch "Reverse-rotation needle-up after thread trimming, p.46" is
used, the length of needle thread remaining after thread trimming becomes longer. So, in this
case, the needle thread clamp device should be set to "OFF".
Needle thread
presser device
– 53 –
To Next Page
Loading...
Need help?
General
