JUKI DDL-8000A User Manual

5-1. Needle-to-hook relationship
5. ADJUSTMENT OF THE MACHINE HEAD (APPLICATION)
Adjust the timing between the needle and the hook
as follows :
1) Adjusting the needle bar height. Turn the hand-
wheel to bright the needle bar down to the lowest
point of its stroke, and loosen setscrew
❶
.
2) Adjusting the needle bar height. Align marker
line (For a DB needle : marker line
A
, For a DA
needle : marker line
C
) on needle bar
❷
with the
bottom end of needle bar lower bushing
❸
, then
tighten setscrew
❶
.
3) Position the needle and the hook
a
.
Loosen the three hook setscrews, turn the hand-
wheel in normal rotation and align marker line (For
a DB needle : marker line
B
, For a DA needle :
marker line
D
) on ascending needle bar
❷
with
the bottom end of needle bar lower bushing
❸
.
4) In this state, align hook blade point
❺
with the
center of needle
❹
. Provide a clearance of 0.04
to 0.1 mm (reference value) between the needle
and the hook, then securely tighten the three
hook setscrews.
If the clearance between the blade point
of hook and the needle is smaller than
the specied value, the blade point of
hook will be damaged. If the clearance
is larger, stitch skipping will result.
WARNING :
Turn OFF the power before starting the work so as to prevent accidents caused by abrupt start of the
sewing machine.
❶
B
❸
A
❷
C
D
A
B
a
0.04 to 0.1 mm
❹
❺
– 52 –

JUKI DDL-8000A Specifications

General

Brand	JUKI
Model	DDL-8000A
Category	Sewing Machine
Language	English