15-3 Sewing data list
Sewing data are those that can be inputted to 99 patterns from pattern 1 to 99 and can be inputted to
each pattern.
The sewing machine has been set in the state that the data which is necessary to set "With/ without edit"
cannot be set at the time of your purchase. Change over the function to "With edit" if necessary for use.
→
Refer to
16. SETTING PROCEDURE OF SEWING DATA WITH/WITHOUT EDIT, p.50
.
No. Item Setting range Edit unit Remarks
Sewing shape
This item selects the shape from among the sewing shapes
of 30 different kinds which the sewing machine has.
→
Refer to
14. SEWING SHAPE LIST, p.36
.
1
〜
30
※Only12kindsofstandardsewingshapescanbeselected
at the time of your purchase. When increasing the kinds
of shapes, perform setting of K04 Sewing shape selection
level of memory switch data.
→
Refer to
26-2 Memory switch list, p.79
.
1 to 30 1 ---
Cloth cut length
This item sets the length of cloth that is cut by
cloth cutting knife. However, in case of bar-
tack shape (Nos. 27, 28, 29 and 30 of S01),
sewing length is set.
3.0 to 120.0 0.1mm ---
By making effective Function of plural motions of
cloth cutting knife of memory switch data, make the plural
motions of knife by the knife size set in the item
Cloth cutting knife size, and the sewing product is cut.
→
Refer to
26-2 Memory switch data list, p.79
.
Knife groove width, right
This item sets the clearance between cloth
cutting knife and right parallel section.
-2.00 to 2.00 0.05mm ---
(Remarks)
※1:Displayedaccordingtotheshape.
※2:Displayedwhenitissettowithedit.
Refer to
16. SETTING PROCEDURE OF SEWING DATA WITH/WITHOUT EDIT, p.50
.
※3:Displayedwhenthefunctionisselected.
To Next Page
Loading...
Need help?
General
