– 72 –
24. PERFORMING CYCLE STITCHING
1
Selection of the cycle data
Display the data input screen.
Only in case of the data input screen (pink), it is
possible to select the cycle data No. In case of
the sewing screen (green), press READY switch
and display the data input screen (pink).
2
Call the cycle data No. selection screen.
When cycle data No. button (A) is pressed,
the cycle data selection screen is displayed.
Cycle data No. which is selected at present and
the contents are displayed in the upper part of the
screen and other cycle data No. buttons which
have been registered are displayed in the lower
part of the screen.
3
Select the cycle data No.
When UP/DOWN button is pressed, the
registered cycle data No. buttons (B) are
changed over in order. Contents of cycle data are
displayed in the buttons. Here, press the cycle
data button (B) you desire to select.
4
Determine the cycle data No.
When ENTER button (C) is pressed, the
cycle data No. selection screen is closed and the
selection has been completed.
24-1 Selection of the cycle data
First, change the sewing mode to the cycle stitching before performing setting.
→
Refer to
20. CHANGING SEWING MODE, p.57
.
A
B
C
To Next Page
Loading...
Need help?
General
