5.1 Truck does not start
Possible cause Actions
Battery connector not plugged in. Check the battery connector
and connect if necessary.
Emergency disconnect switch pressed Unlock the emergency disconnect switch
Key switch in position "O" Set the key switch to position "I"
Battery charge too low Check battery charge and
charge the battery if necessary
Faulty fuse Check fuses, see page 189
Incorrect ISM access module (o)
transponder used
Use correct transponder
Incorrect CanCode (o) entered
Enter correct code, see page 115
Tiller (folding platform) not in brake
position when truck switched on
(for CanDis (o) or on the display unit (2-
inch display) (o), event message E-0914
appears)
Set the tiller to the top or bottom brake
zone, see page 89
Only one side arm is folded out (for
CanDis (o) or on the display unit (2-inch
display) (o), event message E-1926
appears)
Fold both side arms folded in or out.
Actuation sequence not adhered to (for
CanDis (o) or on the display unit (2-inch
display) (o), event message E-1908
appears)
1. Step onto platform.
2. Press the travel switch and move the
tiller into the working position if
necessary.
"Raise load handler" button/"Lower load
handler" button not in home position
when truck switched on (for CanDis (o)
or on the display unit (2-inch display)
(o), event message E-2951 appears)
Do not actuate the buttons
Travel switch not in home position when
truck switched on (for CanDis (o) or the
display unit (2-inch display) (o), event
message E-1901 appears)
Do not actuate the travel switch
Collision safety switch actuated when
truck switched on (for CanDis (o) or on
the display unit (2-inch display) (o),
event message E-1914 appears)
Do not actuate the collision safety switch
107
04.19 en-GB
To Next Page
Loading...
Need help?
General
