5.2 Load cannot be lifted
Possible cause Actions
Truck not operational Carry out all actions listed under "Truck
does not start"
Hydraulic oil level too low Check the hydraulic oil level, see
page 185
Battery discharge monitor has switched
off
Charge the battery, see page 48
Faulty fuse Check fuses, see page 189
Excessive load Observe the rated capacity, see data
plate
Tiller (folding platform) not in brake
position when truck switched on
(for CanDis (o) or on the display unit (2-
inch display) (o), event message E-0914
appears)
Set the tiller to the top or bottom brake
zone, see page 89
Only one side arm is folded out (for
CanDis (o) or on the display unit (2-inch
display) (o), event message E-1926
appears)
Fold both side arms folded in or out.
Actuation sequence not adhered to (for
CanDis (o) or on the display unit (2-inch
display) (o), event message E-1908
appears)
1. Step onto platform.
2. Press the travel switch and move the
tiller into the working position if
necessary.
"Raise load handler" button/"Lower load
handler" button not in home position
when truck switched on (for CanDis (o)
or on the display unit (2-inch display)
(o), event message E-2951 appears)
Do not actuate the buttons
Travel switch not in home position when
truck switched on (for CanDis (o) or the
display unit (2-inch display) (o), event
message E-1901 appears)
Do not actuate the travel switch
Collision safety switch actuated when
truck switched on (for CanDis (o) or on
the display unit (2-inch display) (o),
event message E-1914 appears)
Do not actuate the collision safety switch
Switch in mast implausible
(for CanDis (o) or on the display unit (2-
inch display) (o), event message E-2124
appears)
– Lowering and travelling up to 1.5 km/h
possible
– Park the truck securely, see page 76
– Contact the manufacturer's customer
service department
108
04.19 en-GB
To Next Page
Loading...
Need help?
General
