4.2 How to act in hazardous situations
CAUTION!
If the truck is in danger of tipping over or falling off a loading ramp, proceed as
follows:
u
Abandon the truck.
Z
When travelling on a loading ramp, avoid steering and fold in the side arms as
required to facilitate leaving the truck if it tips over.
4.3 Emergency Disconnect
CAUTION!
Applying maximum braking can result in accidents
Applying the Emergency Disconnect switch during travel will cause the truck to
decelerate to a halt at maximum force. This may cause the load to slide off the load
handler. There is a higher risk of accidents and injury.
u
Do not use the Emergency Disconnect switch as a service brake.
u
Use the Emergency Disconnect switch during travel only in emergencies.
CAUTION!
Faulty or non-accessible Emergency Disconnect switches can cause
accidents
A faulty or non-accessible Emergency Disconnect switch can cause accidents. In
dangerous situations the operator cannot bring the truck to a halt in time by applying
the Emergency Disconnect switch.
u
The operation of the Emergency Disconnect switch must not be affected by any
objects placed in its way.
u
Report any defects on the Emergency Disconnect switch immediately to your
supervisor.
u
Mark defective truck and take out of service.
u
Do not return the industrial truck to service until you have identified and rectified
the fault.
80
04.19 en-GB
To Next Page
Loading...
Need help?
General
