Reducing Camera Shake
When the digital image stabilizer is turned on, camera shake during re-
cording can be effectively reduced.
.
●
The setting of the image stabilizer switches with every touch.
Display Setting
X (Image stabiliz-
er 1)
Reduces camera shake under normal shooting
conditions.
Y (Image stabiliz-
er 2)
Reduces camera shake more effectively when
shooting bright scenes on the wide angle end.
*Only on the wide angle end (approx. 5x)
Z (OFF)
Deactivates image stabilizer.
Memo:
●
It is recommended to switch off this mode when using a tripod and re-
cording a subject with little movement.
●
Complete stabilization may not be possible if camera shake is exces-
sive.
●
This setting is effective for video recording only.
Checking the Captured Image Immediately
You can check the most recently captured images while in the recording
mode. (Quick Review)
.
Memo:
●
You can also delete A the image after checking.
●
Quick Review can no longer recall the most recently captured image
once the power is turned off.
Use the playback mode to check the image in this case.
Taking Still Images in Auto Mode
You can record without worrying about the setting details by using the au-
to mode.
1
Open the LCD monitor and select the still image mode.
(Open the lens cover for GZ-HM300.)
.
●
The still image mode icon appears.
2
Check if the recording mode is Auto.
.
●
If the mode is Manual, touch the G/H button.
The mode changes between Auto and Manual with every touch.
3
Set the focus on the subject.
.
●
When focused, the focus icon lights up in green.
4
Take a still image.
.
●
PHOTO lights up when a still image is being captured.
Recording
23
To Next Page
Loading...
Need help?
General