JVC HR-XV1EK User Manual

21
Repeat Playback
To cancel the auto repeat mode, follow
the above steps 1 and 2, then select "OFF"
and confirm by pressing SET UP MENU.
Note:
If the Repeat function is switched
on, the playback will continue until
it reaches the tape-end and then
rewind to the beginning of the tape.
This process will repeat until the
unit is turned off.
To set the Repeat function
• Turn on the TV and select the VCR channel on TV.
• Press VCR to select the VCR mode.
Preparation
3
Press SET UP MENU repeatedly until the TV picture
appears. If "ON" has been selected, the tape will be
repeatedly played.
1
Press SET UP MENU.
Press
▲ or ▼
to select the AUTO
REPEAT.
Press or to select
[ON] or [OFF].
2
SELECT : /
CHANNEL SETUP
ENTER
EXIT
: OK
: MENU
VCR SETUP
AUTO REPEAT ON
SYSTEM SETUP
TIMER REC SET
SELECT : /
CHANNEL SETUP
ENTER
EXIT
: OK
: MENU
VCR SETUP
AUTO REPEAT OFF
SYSTEM SETUP
TIMER REC SET
2A77501B E(18-23) 5/30/02, 9:22 PM21

JVC HR-XV1EK Specifications

Power

AC voltage	230-240 V
frequency	50 Hz
operation power consumption	22 W
standby power consumption	5 W

Audio Characteristics

audio in jack level	500 mV, 50 kΩ
audio out jack level	500 mV, 1 kΩ
SCART-socket audio	500 mV, 50 kΩ
SCART-socket video	1 Vp-p, 75 Ω

DVD Specifications

DVD signal system	PAL
applicable disc types	DVD (12cm, 8cm), CD (12cm, 8cm)
DVD frequency response	4Hz - 22KHz
CD frequency response	4Hz - 20KHz

Weight and Dimensions

weight	4.5 kg
width	430 mm
height	99 mm
depth	310.5 mm