24
Preparation:
• Turn ON the TV and select the VCR channel on TV.
• Make sure TV/VCR/DVD switch has been slided to VCR/DVD. Then
press VCR to select the VCR mode. (The VCR indicator will light)
1
Load a blank cassette tape with the
erase prevention tab intact. (The
DVD/VCR will automatically turn
on.)
2
Select the program(e.g.29) you want to record with PR +/– or
number keys.
1~9 : e.g. 5 = press “5”
10~80 : e.g. 29 = press “2” and “9”.
3
If a recording in Long Play mode is intended, press (TAPE
SPEED) to display "LP". (see Note below)
4
On the VCR, press 2.
Or on the Remote, while holding 2,
press .
" " will appear on the screen for
about 4 seconds and “REC” will
appear on the display.
If the erase prevention tab is removed, the tape will eject when
both the 2 and
are pressed for recording. (see p.18)
To Stop Recording
Press 3.
To Stop Recording Temporarily
To stop a recording for a short
period of time press 4. Press this
button again if you want to resume
the recording.
Attention:
A safety circuit turns the pause mode off automatically after 5
minutes, and the DVD/VCR will stop the recording mode.
REC
VCR
REC
VCR
Recording a TV Programme
Notes:
• Since the DVD/VCR has a built-in TV
tuner the TV set may be turned off when
recording. The TV set may only be used
to check for accurate program adjust-
ments or to monitor recordings.
• You can confirm on the TV-screen
whether you selected SP or LP. Press
OSD to see the status display. (see
page 25)
• If you wish to watch the DVD playback
during the normal recording on VCR,
press DVD to change to DVD mode and
perform the DVD playback (see page
38).
CH 29
INDEX
VCR
VCR
2A77501B E(24-29) 5/30/02, 9:22 PM24
To Next Page
Loading...
Need help?
Power
Audio Characteristics
Weight and Dimensions
