50
Select “ON” to activate the daylight-saving function if you are in a daylight saving
time zone (effective for NTP mode only), and then choose the starting time ,ending
time and time adjustment.
Please click the “Save” button to save your settings. You can also
click the left button “Reset to Default” to set all the data and options
as defaults.
Update
You can update system firmware if the update file is available. It is the customer's
responsibility to update firmware. All camera motions will shut down during
firmware update. Close any other screens before starting a firmware update. Never
disconnect power and LAN cable during the firmware update process. Rebooting
the camera after firmware update may take approx. 15 minutes. After you finish FW
update, please reboot your computer first time. Be careful, power can’t be shut
down when you’re updating firmware. Otherwise, it will cause FW update failure
and you have to call back to maintenance.
Figure 4-43 Firmware Update
Configuration
Video Type
Users can select “NTSC” or “PAL” according requirement.
Flicker by fluorescent light can be reduced by selecting PAL mode if the public
power is 50Hz, or NTSC mode if the power is 60Hz.
To Next Page
Loading...
Need help?
General
