3 Safety Functions
3.1 General instructions
Danger
Electric Shock
The COMBIVERT is operated with dangerous voltages which can cause
death or serious injury.
The COMBIVERT can be adjusted by way that in regenerative operation
energy is regenerated into the mains also during mains power failure.
Therefore a dangerous high tension can exist in the unit after switching
off the supply system.
Before working with the unit check the isolation from supply by
measurements in the unit.
Care should be taken to ensure correct and safe operation to minimise
risk to personnel and equipment.
Danger
Uncontrolled start (STO) and free running (SBC) of the drive is possible
by improper installation of the safety technology. This may cause death,
serious bodily injuries or substantial damage to property.
Therefore the safety functions may only be installed and put into opera-
tionbyqualiedpersonnelwhicharetrainedinsafetytechnology.
Attention
Observe Standards
The COMBIVERT must not be started until it is determined that the in-
stallation complies with 2006/42/EC (machine directive) as well as the
EMC directive (2004/108/EC)(note EN60204).
The COMBIVERT meets the requirements of the Low-Voltage Directive
2006/95/EC. The harmonized standard of the series EN 61800-5-1 (VDE
0160) is used.
This is a product of limited availability in accordance with IEC 61800-3.
This product may cause radio interference in residential areas. In this
case the operator may need to take corresponding measures.
16
SAFETY FUNCTIONS
To Next Page
Loading...
Need help?
General
