EasyManuals Logo
Home>Keithley>Power Supply>2302

Keithley 2302 User Manual

Keithley 2302
348 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #50 background imageLoading...
Page #50 background image
2-10 Basic Power Supply Operation
Output bandwidth
The battery and charger channel’s output bandwidth control has HIGH and LOW settings.
The HIGH setting will result in the fastest response with dynamic loads but, could be unstable
with certain loads. The LOW setting mode will have a slower response but will be stable for most
loads.
Testing the performance of the battery charger circuitry in a handset does not require the high
bandw
idth performance in channel #1 or channel #2 of the Model 2306. Since a charger circuit
is a voltage regulated circuit, it resembles a high capacitance load to the output of the 2306. For
this type of application, the LOW bandwidth output mode provides increased stability and elim-
inates oscillations that may occur.
The bandwidth can be user programmed at any time. However, if the output is off or the cur-
rent range is not 5A, output bandwidth is automatically set to
low as summarized in Table 2-2.
Table 2-2
Output bandwidth setting for a channel
Output Current Bandwidth
ON 5A LOW or HIGH (user selectable)
OFF 5mA or 5A LOW
OFF/ON 5mA LOW
NOTE The 5mA current range (Table 2-2) may be selected from the front panel, over the bus,
or through autoranging.
Procedure
NOTE This procedure assumes that the appropriate current range is already selected along
with current limit mode and voltage protection.
To set output bandwidth from the front panel:
1. Press the MENU key to access the main menu.
2. Select OUT BANDWIDTH #1 or #2 by scrolling through the primary menu items (use
the
â–² and â–¼ keys to scroll). Scroll until OUT BANDWIDTH is displayed on the bottom
line.
3. Select channel for bandwidth. Toggle between OUT BANDWIDTH #1 or #2 using the
â–²
and
â–²
keys.
4. Press ENTER.
5. Use the
â–² and â–¼ keys to set the desired bandwidth setting (HIGH or LOW). Setting
changes can be cancelled by pressing MENU.
6. Press ENTER to save and return to main menu.
Test Equipment Depot - 800.517.8431 - 99 Washington Street Melrose, MA 02176
TestEquipmentDepot.com

Table of Contents

Other manuals for Keithley 2302

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Keithley 2302 and is the answer not in the manual?

Keithley 2302 Specifications

General IconGeneral
BrandKeithley
Model2302
CategoryPower Supply
LanguageEnglish

Related product manuals