Getting Started 1-7
Remote display option
NOTE The remote display option cannot be used with the Model 2306-VS
If mounting the power supply in a location where the display cannot be seen or the controls
are no
t easily accessible, use the optional Model 2304-DISP or 2306-DISP Display Module (see
Figure 1-4). This remote display module includes all front pane
l instrument controls/features
(with the exception of power). All features/menus work as described for the Model 2306
(exceptions are noted). A 9 foot cable attaches the remote display to the rear of the power supply
allo
wing the unit to be operated remotely.
OPERATE
ENTER
SET
DISPLAY
MENU
LOCAL
2304-DISP REMOTE DISPLAY
igure 1-4
2304-DISP Remote display
option (2306-DISP similar)
NOTE When using the remote display, VFD BRIGHTNESS may not appear in the main menu
(dependent on the firmware revision in the unit).
Plug the remote display module into the rear panel connector labeled “REMOTE DISPLAY
OPTIO
N” (see rear panel in Figure 1-1). When plugged in, the main display module is disabled
with the following message displayed:
REMOTE PANEL
ENABLED
When the remote display module is unplugged, control returns to the main display module.
NOTE When connec
ting or disconnecting the remote display, allow a few seconds for the
power supply to recognize the action. Fast, repeated connects/disconnects of the
remote display may cause the power supply to hang or appear to hang. Disconnecting
the remote display and waiting a few seconds to reconnect it may clear the problem.
If not, cycling power on the power supply clears the condition.
Test Equipment Depot - 800.517.8431 - 99 Washington Street Melrose, MA 02176
TestEquipmentDepot.com
To Next Page
Loading...
Need help?
General
