DAQ6510 Data Acquisition / Multimeter System
2 DAQ6510-900-01Rev. A / April 2018
P
power
on • 2-3
POWER switch • 2-1
Pre-scan monitor • 1-3, 10-1, 10-3
R
remote command interface • 3-1
Remote communications interfaces • 3-1, 8-3
Review event messages • 2-7
RS-232 • 3-12
S
SCAN swipe screen • 2-14
Scanning low-level DCV • 6-1, 6-3
Scanning resistors using 4W measurement • 7-1
Scanning resistors using 4-wire measurements • 7-5
Scanning temperature using thermocouples • 1-3, 5-
1
SCPI • 3-18
Scripts menu • 2-18
Scroll bars • 2-5
SECONDARY swipe screen • 2-11
Select items on the touchscreen • 2-5
Set the GPIB address • 3-12
Set up automatic LAN configuration • 3-3
Set up LAN communications on the computer • 3-4
Set up LAN communications on the instrument • 3-3
Set up manual LAN configuration • 3-4
SETTINGS swipe screen • 2-9
Speed scanning for increased production test
throughput • 9-3
Speed scanning for increased test throughput • 9-1
STATISTICS swipe screen • 2-10
Supported remote interfaces • 3-2
Swipe screen heading bar • 2-7
System menu • 2-19
T
Test results • 5-7, 7-8, 8-7, 9-7
Thermocouple temperature scanning • 5-3
Touchscreen display • 2-2, 2-5
Trigger menu • 2-18
Troubleshooting/FAQ • 1-3, 11-1
TSP • 3-18
TSP-Link • 3-14
Turn the DAQ6510 on or off • 2-4
U
Unpack and inspect • 3-9, 3-12, 3-14
USB communications • 3-5
Use the LXI Discovery Tool • 3-5
USER swipe screen • 2-12
Using a remote interface • 1-3, 3-1
Using SCPI commands • 5-5, 6-4, 7-6, 8-5, 9-4, 10-4
Using the front panel • 5-4, 6-4, 7-5, 8-4, 10-3
Using the web interface • 3-2, 3-15
Using TSP commands • 5-6, 6-6, 7-7, 8-6, 9-6, 10-5
V
Views menu • 2-18
W
Wait for the LAN status indicator to turn green • 3-5
warranty • 1-2
Web interface Home page • 3-17
Welcome • 1-1
What is the ethernet port number? • 11-5
Where can I find updated drivers? • 11-1
Why can't the DAQ6510 read my USB flash drive? •
11-3
Why did my settings change? • 11-5
To Next Page
Loading...
Need help?
General
