A
About this section • 11-1
Additional DAQ6510 information • 12-1
Additional information • 3-11, 3-14, 3-15
Adjust the backlight brightness and dimmer • 2-6
Application examples • 1-3
B
backlight brightness • 2-6
Basic front-panel measurements • 4-3
C
Channel menu • 2-17
Check communication settings • 3-3
command
command set • 3-18
Communicate with the instrument • 3-6
Connect a computer to the DAQ6510 using USB • 3-
5
Connect GPIB cables to your instrument • 3-10
Connect the power cord • 2-4
Connect to the instrument web interface • 3-15
Contact information • 1-2
D
Determining the command set you will use • 3-18,
11-1
Device connections • 4-2, 5-2, 6-2, 7-3, 8-2, 9-2, 10-
2
display
touchscreen • 2-5
Documentation set • 1-2
E
Enter information • 2-6
Equipment required • 5-1, 6-1, 7-2, 8-1, 9-1, 10-1
Equipment required for this example • 4-1
extended warranty • 1-2
Extended warranty • 1-2
F
front panel
interface • 2-1
using • 2-1
Front-panel overview • 1-3, 2-1
FUNCTIONS swipe screen • 2-9
G
GPIB
Install • 3-9
GPIB communications • 3-9
GRAPH swipe screen • 2-12
H
How do I change the command set? • 11-3
How do I save the present state of the instrument? •
11-4
How do I upgrade the firmware? • 11-2
I
Identify the instrument • 3-17, 3-18
Install the KTTI-GPIB accessory card • 3-9
Install the KTTI-RS232 accessory card • 3-12
Install the KTTI-TSP accessory card • 3-14
Installation • 3-9, 3-12, 3-14
Instrument power • 2-3
Interactive swipe screens • 2-7
Introduction • 1-1, 1-3, 4-1, 5-1, 6-1, 7-1, 8-1, 9-1,
10-1
Introduction to this manual • 1-1
Is there any software to help me get started • 11-2
L
LAN communications • 3-2
LAN troubleshooting suggestions • 3-3, 3-16
M
Making basic front-panel measurements • 1-3, 4-1
Making connections • 3-13, 3-15
Measure Menu • 2-17
MENU key • 2-16
Menu overview • 2-2, 2-16
Mixed function multi-channel scanning • 8-1, 8-3
N
Next steps • 1-3, 12-1
O
Organization of manual sections • 1-3
Index
To Next Page
Loading...
Need help?
General
