In this section:
Remote communications interfaces.......................................... 3-1
Supported remote interfaces .................................................... 3-2
GPIB communications .............................................................. 3-2
LAN communications................................................................ 3-5
USB communications ............................................................... 3-7
Using the web interface .......................................................... 3-11
Determining the command set you will use ............................ 3-14
Remote communications interfaces
You can choose from one of several communication interfaces to send commands to and receive
responses from the Model DMM7510.
You can control the Model DMM7510 from only one communications interface at a time. The first
interface on which it receives a message takes control of the instrument. If another interface sends a
message, that interface can take control of the instrument. You may need to enter a password to
change the interface, depending on the access mode.
The Model DMM7510 automatically detects the type of communications interface (LAN, GPIB, or
USB) when you connect to the respective port on the rear panel of the instrument. In most cases, you
do not need to configure anything on the instrument. In addition, you do not need to reboot if you
change the type of interface that is connected.
Section 3
Using a remote interface
北京海洋兴业科技股份有限公司（证券代码：839145）
To Next Page
Loading...
Need help?
General
