BLANK MD
Can't COPY
Can't EDIT
Can't REC
DEFECT
Din UNLOCK
DISC ERR
DISC FULL
FOCUS ERROR
MECHA ERR**
NAME FULL
NO DISC
NOT AUDIO
PLAYBACK MD
PROTECTED
TEMP OVER
TOC ERR**
TOC FULL**
TOC W ERROR
U TOC ERR**
U TOC W ERR
? DISC
0-00:00
**Number or symbol
Error messages Meaning Remedy
Nothing is recorded.
•
•
No copy can be made because of the SCMS copyright
system.
• A track cannot be edited.
• Recording cannot be pertormed correctly due to
vibration.
• Since this MD has scratches on it, the recording
operation was skipped.
• Poor connection of the digital cable.
• The disc damaged.
• The TOC information is not recorded on the disk or the
date contains.
• The MD is out of recording space.
• A MD has not been loaded.
• The disc data cannot be read.
• There is a mechanical problem and the disc is working
properly.
• The number of characters for the MD name or track
name exceeds 40.
• MD has not been loaded.
• MD data cannot be read.
• The data recorded on this disc is not audio data.
• You tried to record on a playback-only disc.
• The MD is write protected.
• The temperature is too high.
• The MD is excessively damages
• There is no space left for recording character infomation
(track names, disc names, etc.)
• Trouble has occurred.
• The TOC infomation on this disc does not meet the
MD specifications or it cannot be read.
• The TOC infomation could not be created properly due
to a mechanical shock or to scratches on the disc.
• The MD contains an error.
• Music is not being recorded.
• Replace the MD wiht a recoded disc.
• Record using the analogue cable.
• Change the stop position of the track and then try
editing it.
• Stop vibration and try again.
• Replace the disc with another recordable disc.
• Connect the digital cable securely.
• Reload the disc or replace it.
• Replace the disc with another recordable disc.
• Reload the MD.
• Reset the microprocessor referring to "If a problem
occurs".
• Shorten the MD or track name.
• Load a MD.
• Reload the MD.
• Select another track.
• Replace the MD.
• Raplace it with a recordable MiniDisc.
• Move the write protection tab back to its original
position.
• Turn off the power, and wait for a whilst.
• Replace the disc with another disc.
• Replace the MD with another recordable disc.
• Contact a KENWOOD Authorized Sevicing Dealer or
KENWOOD Authorized Sevice station.
• Replace it with another MD.
• Erase all the data, and try recording.
• Turn off the power, and try to write the TOC-
information again. (Remove any source of shock or
vibration whilst writing.)
• Replace the disc with another disc.
• Replace the disc with a recorded disc.
When an error message is displayed, proceed as follows:
To Next Page
Loading...
Need help?
Digital Audio Performance
