Kenwood PS Series User Manual

6-21 Resetting Over-Voltage Protection
If the OVP circuit functions while the PS Series is running, the output is
turned off, the OUTPUT LED ® goes off, and the OVP LED © goes on.
OUTPUT LED goes off.
OVP LED goes on.
OResetting procedure 1
Deactivate the POWER switch (D on the front panel (switch released). When
all LED
9
s has gone off, press the POWER switch to activate it (switch
depressed). The OVP function is reset.
OResetting procedure 2 (In case that the main relay is remote-controlled)
DDeactivate the external switch connected between pins 18 and 19 of the
control terminal block Ji © on the rear panel. Al 1 digits on the
voltmeter (2) and ammeter (3) on the front panel go off, except the
decimal points. The OVP LED © also goes off, and the OVP function is
reset.
2)Then, activate the external switch again. The PS Series becomes ready for
operation in approx. three seconds. (See the figure on the following page.)
51

Kenwood PS Series Specifications

General

Brand	Kenwood
Model	PS Series
Category	Power Supply
Language	English