35
Remote Control
•“Shift” appears in the display.
1
2
Press the SHIFT key.
Press the MUSIC, MOVIE, or TV key repeatedly to display
the remote control mode for the component you want to
control.
3
Execute the desired operations.
• See “Remote operation of other components” for a list of keys
available with each component. ‚
The operation mode remains set at the component specified in
step 2.
To return control to the original component, press SHIFT and
then press the MUSIC or MOVIE key to return to the original
control mode.
• Pressing any other keys after the SHIFT key cancels the shift function
and sends the normal code associated with the respective key.
• The input selector does not change during this operation.
The component to be controlled
This operation lets you change the remote control operation mode without
changing the input selector.
You may find this useful when you want to control one component while
using another. (For example, if you want to rewind the tape deck while
listening to a CD.)
VCR
Shift
Menu
DVD
Shift
Menu
• To operate a TV, start form step 2.
Press the MUSIC, MOVIE, or TV key until the desired source
appears.
MUSIC, MOVIE,
TV
+
–
+
–
SHIFT
During operation, make sure you start the next step within 8
seconds of completing the previous one. If more than 8
seconds elapse between any two steps, press the display
operation key so that the display appears.
Changing (confirming) the operation mode
The macro play function allows you to set the remote to control several
components in succession. After completing this setup, you can perform
a series of operations automatically. Enter the setup codes for the
components you want to control beforehand.
Preparing for automatic operations
(MACRO play)
1
Make a plan of the macro play you want to Setup.
The order of the operations may be fairly complex and you may
not be remember all of the necessary commands during the
setup procedure.
Use the space provided below to write down the operations in
the order you are going to enter them.
1!
2@
3#
4$
5%
6^
7&
8*
9(
0)
• The example below shows the plan for step 4 (which occupies a total
of 6 steps) :
1 TV + AV. POWER 2 steps
2 FUNCTION SHIFT + 3 2 steps
3 MOVIE 1 steps
4 AV. POWER 1 steps
Total 6 steps
• If you attempt to store more than 20 steps, “Full” appears and exit
the macro programming mode.
• Enter channel numbers (for the monitor TV, etc.) exactly as you would
using the original remote.
• When you select the input by using the MUSIC, MOVIE, or TV key,
it is counted as 1 step even if you press these keys repeatedly.
2
Press and hold the MACRO key for more than 2 seconds.
•“MACRO MEMORY” appears in the display.
Select MACRO
MACRO MEMORY
Menu
MACRO
MUSIC, MOVIE,
TV
+
–
+
–
During operation, make sure you start the next step within 8
seconds of completing the previous one. If more than 8
seconds elapses between any two steps, the remote control
unit exits from the MACRO play mode.
• Up to 20 steps can be memorized for each macro.
Remote control operations
*509/33-39/EN 3/15/01, 2:17 PM35
To Next Page
Loading...
Need help?
Audio Specifications
