PRS/PRJ/ARS/ARJ-BA-def-0622 97
3 Fundamental information (general)
3.1 Intended use
The balance you have purchased is to be used to determine the weight of the material to
be weighed. It is intended to be used as a “non-automatic” balance, i.e. the material to be
weighed is manually and carefully placed in the centre of the weighing plate. The
weighing value can be read off after a stable weighing value has been obtained.
3.2 Inappropriate use
Do not use the balance for dynamic weighing, if small quantities of the material to be
weighed are removed or added. The “stability compensation” function in the balance itself
can result in incorrect weighing results being displayed! (Example: Slowly draining fluids
from a container on the balance.)
Do not leave a permanent load on the weighing plate. This can damage the measuring
equipment.
Be sure to avoid impact shock and overloading the balance in excess of the prescribed
maximum load rating (max.), minus any possible tare weight that is already present. This
could cause damage to the balance.
Never operate the balance in hazardous areas. The standard model is not explosion-
proof.
Structural alterations may not be made to the balance. This can lead to incorrect weighing
results, faults concerning safety regulations and also to serious damage to the balance.
The balance may only be used in compliance with the described guidelines. Varying
areas of application/planned use must be approved by KERN in writing.
3.3 Guarantee
The guarantee is not valid following
• non-observation of our guidelines in the operating instructions
• use other than for the applications described
• alteration to or opening of the device
• mechanical damage and damage caused by media, liquids, or natural wear and tear
• inappropriate installation or electric installation
• overloading of the measuring equipment
To Next Page
Loading...
Need help?
General
