To Next Page

To Previous Page

PRS/PRJ/ARS/ARJ-BA-def-0622 107

6.10.2 External calibration with freely selectable weight

(only ARS/PRS models)

For an external calibration with user-definable weight, “SET CALIBRATION MODE EXT.-

DEF.” must be selected in the configuration menu (see Chapter 8.6 “Calibration

functions”).

Then, the effective value of the calibration weight (DEF. n.nnn g) must be entered with up

to ten times precision when compared with the balance.

NOTE

If calibration is carried out with the free weight, then only this weight may be used.

Then proceed as follows:

• Switch to “WEIGHING” using the “ ” key

CALIBRATION

• Press “CAL” until “CALIBRATION” appears.

- - 0000 g

• The balance carries out a zero measurement

(0000 g is shown flashing)

- - 372 g

• After the zero measurement has been taken,

the display flashes with the previously

entered calibration weight

• Place the calibration weight on the pan

- - 372 g

• The display flashes rapidly

• Calibration is complete when the display

stops flashing (the exact weight is shown)

+372.15 g

KERN PRS User Manual

Questions and Answers: