To Next Page

To Previous Page

106 PRS/PRJ/ARS/ARJ-BA-def-0622

The calibration of the balance is set in the configuration menu (see Chapter 8.6

“Calibration of the balance”).

Possible types of calibration, depending on the balance model:

• External calibration by means of ICM (Intelligent Calibration Mode)

• External calibration with freely selectable weight

• Internal calibration

• Automatic calibration

NOTE

The calibration can be interrupted at any time by pressing the “ON/OFF” key.

6.10.1 External calibration by means of ICM

(only ARS/PRS models)

Depending on the type of balance, calibration weights in steps of 10 g, 50 g, 100 g and

500 g can be used, where the calibration weight must relate to the accuracy of the

balance.

For an external calibration by means of ICM, “SET CALIBRATION MODE EXTERNAL”

must be selected in the configuration menu (see Chapter 8.6 “Calibration functions”).

• Switch to “WEIGHING” using the “ ” key

CALIBRATION

• Press “CAL” until “CALIBRATION” appears.

- - 0000 g

• The balance carries out a zero measurement

(0000 g is shown flashing)

- - 2000 g

• After the zero measurement has been taken,

the display flashes with the recommended

calibration weight

• Place the calibration weight on the pan

- - 2000 g

• The display continues to flash

• Calibration is complete when the display

stops flashing

+ 2000 g

KERN PRS User Manual

Questions and Answers: