PRS/PRJ/ARS/ARJ-BA-def-0622 111
6.11 Suspended weighing
Objects which, because of their size or shape, cannot be put on the scale, can be
weighed by means of suspended weighing.
Proceed as follows:.
Turn the balance off.
• Remove the scale-pan and the scale pan support and turn the balance over.
• Push the metal-cover (1) on the underside of the balance to one side.
• Hang a small hook (available as an accessory) into the aperture (3) of the now
visible metal casting (2).
• Place the balance over an opening.
• Replace the scale pan support and the scale pan.
• Level the balance.
• Switch on the balance.
• Hang the object to be weighed on the hook and carry out the weighing.
Fig.: Setting up the balance for suspended weighings
CAUTION
Take care that the hooks used for the suspended weighing are stable enough to
safely hold the goods which you wish to weigh.
NOTE
Take care that no dirt or moisture can get into the balance while the scale pan support is
removed.
After completing the suspended weighing, the opening on the underside of the balance
must be closed again (dust protection).
To Next Page
Need help?
General
