Kohler Decision-Maker 550 User Manual

208 Section 10 Governor Adjustments TP-6356 4/12
Parameter Default Settings, continued
No. Parameter Name
Default Settings
A-352184 GM17121 GM17644-4* GM28800-1 GM28801-3
1 No. of flywheel teeth 0 0 0 0 0
2 Set Speed A (Hz) 3550 3550 1000 3550 3550
3
Set Speed B (Hz) [
-- -- -- -- --
4a
Idle Speed (Hz) ]
2130 1935 50 1935 1935
4b Idle Speed (Hz) -- -- -- -- --
5 Proportional 35 50 25 35 45
6 Integral 25 80 50 70 60
7 Derivative 39 35 25 39 35
8 OVG @ Set Speed A (gain potentiometer) 20 20 -- 20 20
9 OVG @ Set Speed B -- -- -- -- --
10 OVG @ Idle 20 20 20 20 20
11 Gain Factor 5 22 20 5 8
12 Speed Filter 16 16 16 16 16
13 Idle Hold Time (sec.) 0 0 0 0 0
14 Accel Rate (Hz/sec.) 1000 1000 1000 1000 3000
15 Decel Rate (Hz/sec.) 1000 1000 1000 1000 3000
16 Startup Rate (Hz/sec.) 2000 2000 1000 2000 2000
17 Startup Limit -- -- -- -- --
18 Torque Limit -- -- -- -- --
19 Integral Low Limit 0 0 0 0 0
20 Integral High Limit 99 40 99 40 40
21 % Droop -- -- -- -- --
22 No Load Calibration -- -- -- -- --
23 Full Load Calibration -- -- -- -- --
24 Password 0 0 0 0 0
25 Overspeed limit (Hz) 6000 6000 6000 6000 6000
26 Set Speed A Min. (Hz) 1000 1000 10 1000 1000
27 Set Speed A Max. (Hz) 5000 5000 11000 5000 5000
28 Set Speed B Min. (Hz) -- -- -- -- --
29 Set Speed B Max. (Hz) -- -- -- -- --
30 Idle Speed Min. (Hz) 500 500 10 500 500
31 Idle Speed Max. (Hz) 5000 5000 11000 5000 5000
32 Duty Cycle Limit 95 95 95 95 95
33 Startup Speed (Hz) 1000 1000 1000 1000 1000
34 Startup Duty Cycle 40 40 30 40 40
* Six default settings
[ Set speed A is set so generator set runs at 50 Hz. To get 60 Hz setting, multiply number of flywheel teeth by 30.
] Idle speed frequency is set so engine run at 900 rpm in idle mode.

Kohler Decision-Maker 550 Specifications

General

Brand	Kohler
Model	Decision-Maker 550
Category	Portable Generator
Language	English