TP- 7006 2/2112 Section 1 OnCue Plus Navigation
1.4.2 Change Generator Information
The generator display name, location, dealer, and
password can be adjusted in OnCue Plus. To change
these settings, select Generator Information from
Device Actions. See Figure 1-7.
To adjust any of the settings, select the appropriate
section as shown in Figure 1-9.
Figure 1-9 Generator Information
Display Name
When a generator is connected for the first time, the
generator name displayed in OnCue Plus will be the
generator serial number. Use the Display Name setting
to change the name to something that identifies the
generator. For example, you can rename the unit using
your name or a location. If your dealer or distributor will
be monitoring the generator, use a name that
distinguishes your unit from other customers’
equipment. Names must contain at least four
characters, and can use letters and numbers.
To assign the name to the generator set, select Display
Name. Type in the new name and select SAVE.
Note: Changing the display name will change it on all
accounts that monitor the generator. The
customer and the dealer cannot have different
names for the same generator.
See Figure 1-10.
Figure 1-10 Display Name
Generator Location
It is best to include the address of the generator location.
This allows the dealer to use a map function to easily find
the generator location.
Select Location. Begin typing in the address and select
the correct address when you see it in the list. Select
SAVE.
SeeFigure1-11.
Figure 1-11 Location
To Next Page
Loading...
Need help?
General
