TP- 7006 2/2126 Section 1 OnCue Plus Navigation
1.13.3 Notifications
OnCue Plus can be configured to send email or SMS
text messages alerting the recipient of generator set
faults, exercise updates, and maintenance reminders.
Email and text messages include:
D Display name
D Generator state
D Description of the event
The events s hown in Figure 1-43 will generate an email
message.
A separate message is sent for each active warning and
shutdown. If multiple warnings clear or shutdowns reset
at the same time, you will receive one email indicating all
information. See the generator set Operation Manual for
a list of warnings and shutdowns.
Event Notes
Exercise start/exercise ended
Exercise messages are available if a Kohler Model RXT transfer switch is
connected to the generator.
Generator running/generator stopped
If a Kohler Model RXT transfer switch is connected to the generator, you will see
these messages and the exercise messages when the generator exercises, if both
messages are selected.
Generator in auto / not in auto
If the OFF or RUN buttons on the generator controller are pressed, the unit is not
in AUTO. Remote start/stop commands will not work and scheduled exercises will
not run when the unit is not in AUTO. When AUTO is pressed again, a message is
sent to notify you that the generator has returned to AUTO mode.
Utility loss / utility restored
If a Kohler Model RXT transfer switch is connected to the generator, you will see
these messages indicating utility power outage and restoration.
Communication loss/restored
Loss of communication has no bearing on the generator functioning as a standby
source of power.
Warnings active/cleared
Warning messages are dependent on the generator set. The message will include
information about the cause of the warning; for example, low oil pressure.
Note: Maintenance reminders are considered warnings. Turn on Warnings
active/cleared to receive notifications of maintenance reminders.
Shutdown active/reset
Shutdown messages are dependent on the generator set. The message will
include information about the cause of the shutdown; for example, high engine
temperature.
Figure 1-43 Power System Events that Can G enerate an Email or Text Message
To Next Page
Loading...
Need help?
General
