Komatsu PC130-8 User Manual

30 Testing and adjusting SEN04116-00
PC130-8
3
Preparation work for
troubleshooting of electrical
system 1
a When carrying out troubleshooting of an elec-
tric circuit related to the machine monitor,
engine controller, pump controller, or
KOMTRAX communication MODEM, expose
the related connectors according to the follow-
ing procedure.
a Disconnect and connect the connectors having
special locking mechanisms according to the
procedure shown below.
1. Machine monitor
1) Remove 2 mounting bolts and cover (1).
a One of the mounting bolts is installed
in the cover on the right of the day-
light sensor.
a While removing the mounting bolts,
disconnect connector P31 of the day-
light sensor.
a The following figure shows the model
of the arm crane specification
equipped with a level. If the machine
which you are working on has the arm
crane specification, remove level (2).
2) Remove 1 mounting bolt and duct (3).
3) Insert or connect troubleshooting T-adapt-
ers in or to connectors CM01, CM02, and
CM03 of machine monitor (4).
a Connectors CM02 and CM03 are of
the same type. When returning them,
check the mark plates of the mount-
ing brackets and take care not to
make a wrong connection.
2. Engine controller
1) Open the engine hood.
a The engine controller is mounted on
the cooling frame (on the counter-
weight side).
2) Insert or connect troubleshooting T-adapt-
ers in or to connectors CE01, CE02, and
CE03 of engine controller (5).
a Connectors CE01 and CE02 are fixed
with screws. When disconnecting
them, loosen the screws.
a When returning connectors CE01 and
CE02, tighten the screws to the spec-
ified torque.
3 Screw: 3 ± 1 Nm {0.3 ± 0.1 kgm}

Komatsu PC130-8 Specifications

General

Brand	Komatsu
Model	PC130-8
Category	Excavators
Language	English