10 TUNING THE CHASSIS 40
Info
Turn clockwise to increase damping; turn counterclockwise to reduce damp-
ing.
–
Mount protection cap
.
10.16 Handlebar position
H01188-10
The holes on the handlebar supports are placed at a distance of
from the center.
Hole distance A 3.5 mm (0.138 in)
The handlebar can be mounted in 2 different positions. In this way, the handlebar can
be mounted in the most comfortable position for the rider.
10.17 Adjusting the handlebar position
Warning
Danger of accidents A repaired handlebar poses a safety risk.
If the handlebar is bent or straightened, the material becomes fatigued. The handlebar may break as a result.
– Change the handlebar if the handlebar is damaged or bent.
Preparatory work
– Remove the handlebar cushion.
H01189-10
Main work
–
Remove screws
. Remove the handlebar clamp. Remove the handlebar and lay it
to one side.
Info
Cover the components to protect them against damage.
Do not kink the cables and lines.
–
Remove screws
. Take off handlebar supports
.
–
Position rubber bushings
and push through nuts
from below.
– Place the handlebar supports in the required position.
Info
The handlebar supports are longer and higher on one side.
Position the left and right handlebar supports evenly.
–
Mount and tighten screws
.
Guideline
Screw, handlebar support M10 40 Nm
(29.5 lbf ft)
Loctite
®
243™
– Position the handlebar.
Info
Make sure the cables and wiring are positioned correctly.
– Position the handlebar clamp.
–
Mount screws
but do not tighten yet.
–
First bolt the handlebar clamp with screws
onto the longer, higher side of the
handlebar supports so that both parts touch.
Guideline
Screw, handlebar clamp M8 20 Nm
(14.8 lbf ft)
To Next Page
Loading...
Need help?
General
