7 PREPARING FOR USE
22
7.2 Running in the engine
– During the running-in phase, do not exceed the specified engine performance.
Guideline
Maximum engine performance
During the first 3 operating hours < 70 %
During the first 5 operating hours < 100 %
– Avoid fully opening the throttle!
7.3 Preparing the vehicle for difficult operating conditions
Info
Use of the vehicle under difficult conditions, such as on sand or on wet and muddy surfaces, can result in
significantly increased wear of components, such as the drive train, brake system, or suspension compo-
nents. For this reason, it may be necessary to inspect or replace parts before the next scheduled service.
– Clean the air filter and air filter box. ( p. 58)
Info
Check the air filter approx. every 30 minutes.
– Check the electrical connector for humidity and corrosion and to ensure it is firmly seated.
» If humidity, corrosion, or damage is found:
– Clean and dry the connector, or change it if necessary.
Difficult operating conditions are:
– Rides on dry sand. ( p. 22)
– Rides on wet sand. ( p. 24)
– Rides on wet and muddy circuits. ( p. 25)
– Rides at high temperatures or slow riding. ( p. 25)
– Riding at low temperatures and in snow. ( p. 26)
7.4 Preparing the vehicle for riding on dry sand
– Make sure that no radiator covers ( p. 91) are installed.
V00814-01
– Check the radiator cap.
Value on the radiator cap 1.8 bar (26 psi)
» If the indicated value does not correspond to the setpoint
value:
To Next Page
Loading...
Need help?
General
