KTM 990 SMT User Manual

WHEELS, TIRES 111
12.1Removing the front wheel x
– Raise the motorcycle with the rear wheel stand. ( p. 82)
– Raise the motorcycle with the front wheel stand. ( p. 81)
B00632-10
– Take the speed sensor cable out of the clamp.
– Remove screw  and pull wheel speed sensor  out of the hole with the sleeve.
– Remove screws  from both brake calipers.
– Press back the brake linings with a light lateral tilting of the brake calipers on the brake
disc. Pull the brake calipers carefully back from the brake discs and hang them to one
side.
Info
Do not pull the hand brake lever when the brake calipers are removed.
B00633-10
– Loosen screws  and .
– Unscrew screw  about six turns and press your hand on the screw to push the wheel
spindle out of the axle clamp. Remove screw .
Warning
Danger of accidents Reduced braking efficiency caused by damaged brake
discs.
– Always lay the wheel down in such a way that the brake discs are not dam-
aged.
– Holding the front wheel, withdraw the wheel spindle. Take the front wheel out of the
fork.

KTM 990 SMT Specifications

General

Brand	KTM
Model	990 SMT
Category	Motorcycle
Language	English