COOLING SYSTEM 158
B00676-11
– Place a suitable container under the engine.
– Remove screw .
– Completely drain the coolant.
– Mount screw with a new seal ring and tighten it.
Guideline
Screw, water pump cover M6 10 Nm (7.4 lbf ft)
14.5Filling/bleeding the cooling system x
Warning
Danger of poisoning Coolant is poisonous and a health hazard.
– Avoid contact between coolant and skin, eyes and clothing. If it gets into your eyes, rinse immediately with water and contact
a doctor. Wash affected skin areas immediately with soap and water. If coolant is swallowed, contact a doctor immediately.
Change clothes that have come into contact with coolants. Keep coolant out of the reach of children.
– Reset the fuel tank. ( p. 85)
700629-10
– Ensure that the drain plug on the radiator and the water pump cover are tightened.
– Remove bleeder screw .
To Next Page
Loading...
Need help?
General
