Kyocera FS-C8100DN User Manual

Using the Operation Panel
2-67
6
To set the sleep timer, press [OK]. A blinking question mark (?)
appears.
7
Press  or  to change On to Off.
8
Press [OK]. The sleep timer is turned off.
9
To exit the menu selection, press [Menu].
Sleep Timer Timeout Time
You can adjust the length of time the printer waits before entering Auto Sleep in the absence of
data. The default time is 15 minutes.
The printer reverts to normal operation mode when the printer receives a print job, the operation
panel is operated, or one of the exterior covers is opened.
1
Press [Menu].
2
Press  or  repeatedly until Others > appears.
3
Press .
4
Press  or  repeatedly until >Sleep Timer > appears.
5
To change the timeout time, press [OK]. A blinking cursor (_)
appears.
6
Press  or  to increase or decrease the value at the blinking cursor and set the desired time. The
timer can be set between 5 and 240 min, in 5-minute increments. Use  and  to move the cursor
right and left.
7
When the desired timeout time is displayed, press [OK].
8
To exit the menu selection, press [Menu].
Received Data Dump
You can print data received by the printer as hexadecimal code for debugging programs and files.
1
Press [Menu].
2
Press  or  repeatedly until Others > appears.
>>Auto Sleep
? On
>>Auto Sleep
? Off
Others >
>Sleep Timer >
015min.
>Sleep Timer
015
min.
Others >

Kyocera FS-C8100DN Specifications

General

Brand	Kyocera
Model	FS-C8100DN
Category	Printer
Language	English