Using the Operation Panel
2-69
6
Press [OK] again. Self test appears while the printer is
resetting itself, followed by Please wait and then Ready.
Resource Protection
By default, when you switch from the PCL 6 emulation to another, all downloaded fonts and macros
will be lost. Resource protection preserves these PCL resources in memory so that they remain
intact even when you have switched back to PCL 6.
NOTE: Resource protection requires extra memory to store the downloaded fonts and macros. The
total size of the printer memory recommended for using the resource protection option is affected by
several factors. Refer to Expansion Memory Modules on page 3-5.
By default, resource protection is deactivated.
1
Press [Menu].
2
Press or repeatedly until Others > appears.
3
Press .
4
Press or repeatedly until >Resource Prot. appears.
5
Press [OK]. A blinking question mark (?) appears.
6
Press or to select Permanent, Perm / Temp (Permanent/Temporary) or Off for resource
protection.
7
When the desired resource protection is displayed, press [OK].
8
To exit the menu selection, press [Menu].
Self test
Please wait
Ready
A4 PLAIN
Others >
>Resource Prot.
Permanent
>Resource Prot.
? Permanent
To Next Page
Loading...
Need help?
General