1-2
INSTALLATION PRECAUTIONS
Environment
CAUTION
Avoid placing the copier on or in locations
which are unstable or not level. Such
locations may cause the copier to fall down or
fall over. This type of situation presents a
danger of personal injury or damage to the
copier. ..............................................................
Avoid locations with humidity or dust and
dirt. If dust or dirt become attached to the
power plug, clean the plug to avoid the
danger of fire or electrical shock. ...................
Avoid locations near radiators, heaters, or
other heat sources, or locations near
flammable items, to avoid the danger of fire.
To keep the copier cool and facilitate
changing of parts and maintenance, allow
access space as shown below. Leave adequate
space, especially around the left and right
sides, to allow air to be properly ventilated
out of the copier...............................................
* Additional space will be required when the Document
Processor is to be installed.
Other precautions
Adverse environmental conditions may affect the safe
operation and performance of the copier. Install in an
air-conditioned room (recommended room
temperature: around 73.4ºF (23ºC), humidity: around
50%) and avoid the following locations when selecting
a site for the copier.
• Avoid locations near a window or with exposure to direct
sunlight.
• Avoid locations with vibrations.
• Avoid locations with drastic temperature fluctuations.
• Avoid locations with direct exposure to hot or cold air.
• Avoid poorly ventilated locations.
If the floor is delicate, when this product is moved
after installation, the floor material may be damaged.
During copying, some ozone is released, but the
amount will not cause any ill effect to one's health. If,
however, the copier is used over a long period of time
in a poorly ventilated room or when making an
extremely large number of copies, the smell may
become unpleasant. To maintain the appropriate
environment for copy work, it is suggested that the
room be properly ventilated.
Power supply/Grounding the copier
WARNING
DO NOT use a power supply with a voltage
other than that specified. Avoid multiple
connections in the same outlet. These types
of situations present a danger of fire or
electrical shock. ..............................................
Plug the power cord securely into the outlet.
If metallic objects come in contact with the
prongs on the plug, it may cause a fire or
electric shock. .................................................
Always connect the copier to an outlet with a
ground connection to avoid the danger of fire
or electrical shock in case of an electric short.
If an earth connection is not possible, contact
your service representative............................
Other precautions
Connect the power plug to the outlet closest to the
copier.
The power supply cord is used as the main disconnect
device. Ensure that the socket/outlet is
located/installed near the equipment and is easily
accessible.
Handling of plastic bags
WARNING
Keep the plastic bags that are used with the
copier away from children. The plastic may
cling to their nose and mouth causing
suffocation.......................................................
To Next Page
Loading...
Need help?
General
Weight and Dimensions
