7: Network Settings
EDS1100/2100 Device Server User Guide 41
Network 1 (eth0) Interface Configuration
This page shows the configuration settings for the Ethernet connection and lets you change these
settings.
To view and configure network interface settings:
1. Click Network on the menu bar and then Network 1 > Interface > Configuration at the top of
the page. The Network 1 (eth0) Interface Configuration page appears.
Figure 7-2 Network 1 (eth0) Interface Configuration
2. Enter or modify the following settings:
Table 7-3 Network 1 (eth0) Interface Configuration
Network 1 Interface
Configuration
Settings
Description
BOOTP Client Select On or Off. At boot up, the device will attempt to obtain an IP address from a
BOOTP server.
Notes:
Overrides the configured IP address, network mask, gateway, hostname, and
domain.
When DHCP is On, the system automatically uses DHCP, regardless of
whether BOOTP Client is On.
To Next Page
Loading...
Need help?
General